Search the Community
Showing results for tags 'weld'.
Found 5 results
-
The plastic top of my radiator has a very small crack or hole. Only leaks when it's hot. Cause is faulty radiator cap (changed liao). Any DIY plastic weld or workshop that does such repair to recommend? Thanks.
-
in your opinion, is it worth it? i was following another car and he suddenly swerve to avoid a huge rock, of course, i cannot react similarly because i was quite close behind. i went over the rock and my rear rim suffered dents and crack. the crack release air that caused my Tyre to be half punctured. the valve also seem to be spoilt because i not cannot pump air at the petrol station. the rim is original chrome advan racing rs 18" x 8" PCD 5x100 with 45 offset. tough luck to find a single rim to replace. i tried altc and another workshop they don't have single ones. replacing all 4 rims seems too expensive especially when i am selling my car soon. attached below are some pictures of the cracks.
-
Where to get 3M Windo-Weld, need to use on Engine Mount
Vtim posted a topic in Maintenance & Repairs
Anyone know where to get hold of the 3M Windo-Weld (Primerless) Super Fast Urethane ? My stock engine mounts, especially the lower back are torn and the front one is about to suffer the same fate (after only 50k to 60k km). This 3M Windo-Weld can be used to filled up all the "gaps" in the stock engine mounts ( I will be doing it on a set of new engine mount) and make it last much more longer, most US DIY guys are doing it to their stock engine mount as it is much cheaper than aftermarket Polyurethane engine mount. see here: http://www.raktron.com/misc/mt.htm http://importnut.net/motormount.htm
-
eh... not really modding, so post it here. My centre can (whatever it is call) is very old and crack. Went to change a new one. Was given a metallic blue round one. Will I get myself into trouble on the coming inspection?
-
Hi Just need to weld one pipe (I think it's called the inlet to the muffler?? The one in the second half of the undercarriage). Cos the second hand aftermarket exhaust was bought from a general workshop and they fixed up from me. It was not welded but joined by a " C-clamp" (donna what you called that), and it leaked several times.....went back to same workshop the few times but they just tightened it ). Anyway long story. So any good and cheap specialised exhaust workshop to recommend? Went to MAN yesterday but it was damn crowded, can't even squeeze into the back where the office is Also, any idea the market rate just to jack up the car and weld the one pipe? Thanks
