Search the Community
Showing results for tags 'pillar'.
Found 15 results
-
Here a a pillar DIY project ..... Took longer then I expected due to work comittiment New pillar for the project Drilling and placement
- 30 replies
-
- 2
-
-
- nissan
- qashqai diy pillar
- (and 5 more)
-
happening part is at around 30seconds into the vid
-
Ford B-Max
-
due to my poor judegement, my vehicle got orh bak ka liao... any kind soul can help me guage how much it costs to repair??? any recommend workshop in the west???
-
Hi gurus here, need some help. I'm looking high and low for a Toyota Picnic A pillar console (the plastic piece next to windscreen inside) for speaker customization, no need to be new piece, have been searching many spare part shop, scrapyard and even placing order from some of the Toyota spare parts shop along serangoon area but still in vain. anybody here can give some light? Thanks in advance! Ben
-
Anniliation. RIP. Van passed by the accident site just after it happened, before the police got there. reluctant to stop and help coz am not trained in anyway and my stomach is not strong and unsure of what i would find... purposely passed by the site again 2 hours later.. hopes dashed as i saw 2 tents...... may the men RIP.. [bigcry]
-
anyone read the xin ming news? it happened last night 3+am at jurong west blk 548... apparently 1/2 of the pillar was smashed apart... f.arker sure gonna compensate until siao!
-
Experiencing creaking or squeaking sound from the left A-pillar(with the cover removed) when shocks are felt on the left front wheel. If shock is experienced on both front wheel, no creaking or squeaking sound. Till date, still unable to locate the source. Any pros tink that it could be the A-pillar metal frame structure? Based on the pic, will any of the parts within the circled area contribute to the noise? Wires and the rubber strips are not the source.
-
Shot this last week end... Either the driver's parking skills is very good or he/she simply "Boh Chap".. The car body is only less than 2mm away from the pillar
-
Hi guys, i used to have gauges on my driver side a-pillar, then recently i had them removed.. so rite now got 2 holes on the A-pillar.. Besides getting a new one from the authorised distributor for Mazda, cos its abit too ex so dont relli wanna buy from them, is there any other alternatives for fixing it up? my fren told me to have the a-pillar wrapped up with CF sticker, can cover up holes plus make both A-pillars got the CF look.. or do u guys know where i can go to get the holes patched up, then spray the a-pillars to another colour? THANKS
-
I have D.I.Y. a two meter A-pllar mount. At first tried double-side tape, under hot sun melted and peeled off. Tried also Delcro tape, also suffer same fate under hot sun. Anyone can advise me which is best method to install a A-pillar mounting. Don't intend to drill at all.
-
Anybody remember where is the A-pillar speaker thread The tweeter & mid were mounted on it Wanted to check it out
-
Heart pain ... my mistake. Normally never park there but that day don't know why, I didn't see the pillar behind.Some scratches at the bumper but no dent. The left rear light broke although not quite visible from far.Checked with my SE, he said waste money if change new bumper. He will asked for spray paint and a bit touch up during my 1st servicing this next Monday. As for the light, he said would cost me approximately $140.
-
Hello, Just removed 2 gauges (Voltmeter & Air/fuel meter) from the "A" pillars & left with holes ..... very ugly.... can recomend any place to do patching or is good to purchase a new piece. FYI, going to sell the current car away to dealer on Jan once i get hold of the new car (1 to 1 exchange). rgds jack
