Ad information
Features
High performance Class D mono amplifier with up to 1,500 Watts RMS @ 1 Ohm – a perfect match for all 2 x 2 Ohms subwoofers connected in parallel
Also usable as an ultra broadband amplifier with exceptional sound quality – ideal for High Resolution Audio
Extremely high efficiency and low heat dissipation with minimal dimensions
High damping factor for maximum speaker control
Regulated power supply with Start-Stop capability for extremely stable output power even during voltage drops
TwinPower Link for connecting two amplifiers in bridged mode
Optionally available HELIX Digital Input Module (HDM) to extend the amplifier with an optical digital input in SPDIF format
Technical data
Power RMS ≤ 1% THD+N:
- @ 4 Ohms: Normal operation (One amplifier) - 1 x 500 Watts | TwinPower Link (Two amplifiers) - 1 x 1,760 Watts
- @ 2 Ohms: Normal operation (One amplifier) - 1 x 880 Watts | TwinPower Link (Two amplifiers) - 1 x 3,000 Watts
- @ 1 Ohm: Normal operation (One amplifier) - 1 x 1,500 Watts | -
- bridged @ 4 Ohms: -
- bridged @ 2 Ohms: -
Max. output power per channel*: Up to 1.800 Watts RMS @ 1 Ohm
Amplifier technology: Class D
Inputs:
2 x RCA / Cinch
1 x Remote In
Optional via HDM 1 module: 1 x Optical SPDIF (28 - 96 kHz)
Input sensitivity: RCA / Cinch 0.5 - 8 Volts
Input impedance RCA / Cinch: 6 kOhms
Input impedance highlevel: -
Outputs: 1 x Speaker output
Output voltage RCA / Cinch: -
Signal converter for digital input: -
Frequency response: 10 Hz - 40,000 Hz
Bass boost: -
Highpass: -
Lowpass: -
Bandpass: -
Subsonic: -
Phase: -
Slope high- / lowpass: -
Slope subsonic / lowpass: -
Signal-to-noise ratio digital input: -
Signal-to-noise ratio analog input: 112 dB (A-weighted)
Distortion (THD): < 0.01 %
Damping factor: > 500
Operating voltage: 10.5 - 16 Volts (max. 5 sec. down to 6 Volts)
Idle current: 1250 mA
Fuse: 4 x 30 A LP-Mini-fuse (APS)
Additional features: Input mode switch, TwinPower Link, HDM slot, Start-Stop capability
Dimensions (H x W x D): 50 x 260 x 190 mm / 1.97 x 10.24 x 7.48”
* In typical applications as subwoofer amplifier
- Audio system in car entertainment
- Car air cinditioning servicing / maintenance and repair
- Accessories retail
- Security system
- Car mats
- Solar films and tinting
- Car battery
- Car recorder
- Car power enhancement
Website: http://www.designerice.sg/
Facebook: https://www.facebook.com/DesignerICEEnterprise
Ad information
Features
High performance Class D mono amplifier with up to 1,500 Watts RMS @ 1 Ohm – a perfect match for all 2 x 2 Ohms subwoofers connected in parallel
Also usable as an ultra broadband amplifier with exceptional sound quality – ideal for High Resolution Audio
Extremely high efficiency and low heat dissipation with minimal dimensions
High damping factor for maximum speaker control
Regulated power supply with Start-Stop capability for extremely stable output power even during voltage drops
TwinPower Link for connecting two amplifiers in bridged mode
Optionally available HELIX Digital Input Module (HDM) to extend the amplifier with an optical digital input in SPDIF format
Technical data
Power RMS ≤ 1% THD+N:
- @ 4 Ohms: Normal operation (One amplifier) - 1 x 500 Watts | TwinPower Link (Two amplifiers) - 1 x 1,760 Watts
- @ 2 Ohms: Normal operation (One amplifier) - 1 x 880 Watts | TwinPower Link (Two amplifiers) - 1 x 3,000 Watts
- @ 1 Ohm: Normal operation (One amplifier) - 1 x 1,500 Watts | -
- bridged @ 4 Ohms: -
- bridged @ 2 Ohms: -
Max. output power per channel*: Up to 1.800 Watts RMS @ 1 Ohm
Amplifier technology: Class D
Inputs:
2 x RCA / Cinch
1 x Remote In
Optional via HDM 1 module: 1 x Optical SPDIF (28 - 96 kHz)
Input sensitivity: RCA / Cinch 0.5 - 8 Volts
Input impedance RCA / Cinch: 6 kOhms
Input impedance highlevel: -
Outputs: 1 x Speaker output
Output voltage RCA / Cinch: -
Signal converter for digital input: -
Frequency response: 10 Hz - 40,000 Hz
Bass boost: -
Highpass: -
Lowpass: -
Bandpass: -
Subsonic: -
Phase: -
Slope high- / lowpass: -
Slope subsonic / lowpass: -
Signal-to-noise ratio digital input: -
Signal-to-noise ratio analog input: 112 dB (A-weighted)
Distortion (THD): < 0.01 %
Damping factor: > 500
Operating voltage: 10.5 - 16 Volts (max. 5 sec. down to 6 Volts)
Idle current: 1250 mA
Fuse: 4 x 30 A LP-Mini-fuse (APS)
Additional features: Input mode switch, TwinPower Link, HDM slot, Start-Stop capability
Dimensions (H x W x D): 50 x 260 x 190 mm / 1.97 x 10.24 x 7.48”
* In typical applications as subwoofer amplifier
Merchant information
More items from this seller
Email Enquiry
* indicates compulsory field.