This Racing spec, 2-in-1 voltage stabilizer that consist of Direct-charging Positive cable and Voltage Stabilizer in one. It improves both Horsepower and Torque from Low to High RPM, The Positive cable allows ample charging current to the battery. The results - noticeably improved acceleration, superior engine response, longer lasting battery life, stable voltage, reduced distortion.

In today's world, most vehicle like cars, trucks, buses, motorbikes and so on, require electricity to work properly. The source of the electric current comes from alternator. It is vital for engine it to run, and also electrical equipments.

When the current from alternator is measured with digital volt meter, the reading is inconsistent. This is caused by voltage fluctuation. The fluctuated voltage will cause the voltage signal of the sensors and actuators to fluctuate as well, causing the sensors and actuators to receive irregular signals. Thus  producing inaccurate signals to car's ECU and other electrical circuits. When ECU and electrical equipments work less efficiently, it leads to the degradation of car performance.

The main purpose of Voltage Stabilizer is to minimize voltage fluctuation and reduce distortion. The effect of this will be clean signal to and from sensors and actuators. This will allow ECU to work more efficiently with greater precisions. Therefore, accurate signal will allow engine to perform more efficiently too. 

Before Qmax voltage stabilizer is introduce to the market, countless hours of Research and Developement has been done. This is the key factors on producing high quality Voltage stabiliser.

Qmax Voltage stabilizer is entirely made only with high quality parts. One of the most significant different is, the cable is using copper with over 99.9% purity, coated with Stannum. Inner layer of cable shield contains Nano compound. With this, it enable the current to flow smoothly, extremely good electric conductivity. Currently no other voltage stabilizer is using it. The electronics components used can still work effectively in hot, 105ºC ambient, for over 10,000 hours continuously. Different capacitors used are for reduce all high pass, band pass and low pass distortion.

Features

• Improved gas mileage - up to 21% better fuel economy 
• Reduced emissions - up to 80% reduction of HC
• Improved engine's efficiency
• Double protection from short circuit
• Double layered circuit board
• Prolong electrical & electronic parts life
• Increase electrical/electronic equipments' efficiency
• Extend battery lifespan
• Patented technology in numerous countries around the world
• Sirim QAS international certified
• Simple installation, no modification required, just add-on
• Proven result with Dynomete