Jump to content

Only Change 1 Tyre OK ?


TVT
 Share

Recommended Posts

Is it a must to do alignment after changing tyres?

 

Advisable but not necessary normally. In your case a must. Something is off for your kind of wear. It's about time you change your rear tyres too. I know the recommendation is 2 years, but I usually stretch to 3 year if the tyres permit. Just changed all 4 on my mom's Punto earlier today myself actually.

 

Edit: Saw you did an alignment two weeks ago. No need liao.

Edited by Elfenstar
↡ Advertisement
Link to post
Share on other sites

How about swop with the spare tyre? Keep the bald tyre as spare instead.

 

In mechanical terms, there is no big deal to just change one tyre. The differences in rolling DIA and grip is not going to affect a normal car on the road.

 

Not entirely true. It makes a huge difference in vehicular control if you need to take any emergency maneuvers.

Link to post
Share on other sites

Supercharged

The alignment was done in JB for RM15, and when finish the mechanic didn't give me any report at all. When asked anything wrong, he just say "some alignment was out but now adjusted to correct liao"...... [:(]

Link to post
Share on other sites

Turbocharged

Hi all

 

My front left tyre getting bald soon....but my front right tyre still has plenty of thread, not sure why the in-balance wear for both tyres even thou both were changed at the same time in Jan 2011. Even my rear 2 tyres (used almost 3 years liao) still has plenty of thread.

 

Question is: can I just buy 1 new tyre to replace the front left? Is this advisable in terms of safety considerations and will that cause any drive-shaft damage to my car?

 

Thanks. [:)]

 

how come uneven wear? got do balancing?

Link to post
Share on other sites

Supercharged

you should change all 4. The rear tyres should also be replaced because of age. The compound is hardened over time and this affects the grip.

Budget tight lah....so if possible, trying not to change all 4 tyres at one go... [:(]

Link to post
Share on other sites

The alignment was done in JB for RM15, and when finish the mechanic didn't give me any report at all. When asked anything wrong, he just say "some alignment was out but now adjusted to correct liao"...... [:(]

 

Ummm like that ah. Probably the "some alignment was out" would explain your uneven tire wear. Whether or not it's actually "adjusted to correct liao" is hard to say without printout. I'd personally get another alignment done (with printout) after the new tires are put on, but that's me.

Link to post
Share on other sites

Supercharged

Ummm like that ah. Probably the "some alignment was out" would explain your uneven tire wear. Whether or not it's actually "adjusted to correct liao" is hard to say without printout. I'd personally get another alignment done (with printout) after the new tires are put on, but that's me.

I did told the mechanic one side tyre more botak than the other side...and he said "try drive for about 5,000 km and see got improvement or not"....

 

But, even with if he had corrected the alignment properly, my botak tyre (I believe) won't last another 5,000 km [:(]

Link to post
Share on other sites

was done alignment in jb...cannot use at all...when sent my supercar to Vicom checking, alignment wrong some more...better do it in SG, expensive but no need to run twice and pay twice...very regret do it in JB...their machine su*ks!

Link to post
Share on other sites

The next time if yr car fails the bi-annual inspection on wheel alignment , which is actual a wheel side slip test. That mean yr car is either pulling to the right or left ( lateral movement) Yr wheel angles maybe set right as per manual but your rid still fails the side slip test - this is because both wheels are developing different rotating forces resulting in the pulling. The cause can be due to or compound by wheel pattern wear, wheel bearing wear, tie rod wear, cv joint wear.

The pulling force can be neutralised by just slightly adjusting the toe angle and final test by via a side slip tester.

Edited by Yeobh
Link to post
Share on other sites

The road is curved to the left so that rain water runs to the side.

I never knew the road is curved to the left.

 

I thought the system should be for rain to run to BOTH sides, not just left, correct? Then left front will wear faster if you travel heavily on the left lane, but right front should wear faster if you travel heavily on right lane, right?

Link to post
Share on other sites

I never knew the road is curved to the left.

 

I thought the system should be for rain to run to BOTH sides, not just left, correct? Then left front will wear faster if you travel heavily on the left lane, but right front should wear faster if you travel heavily on right lane, right?

tyre should always change in pair , 1 is not recommended but still some people done that without any issu.

base on your story frontleft motak, i think is likely due to your driving condition like every day up down MSCP clockwise, the outer wheel turn more thus eat more, by rotation your tyre regularly you can more or less equalise the 4 tyres wearing.

by suggestion to you replace 2 new tyre and put you current 2 back old tyre forward (balance first)

place you 2 NEW TYRE at rear (balance it too)

Edited by Roberttan
Link to post
Share on other sites

Supercharged

tyre should always change in pair , 1 is not recommended but still some people done that without any issu.

base on your story frontleft motak, i think is likely due to your driving condition like every day up down MSCP clockwise, the outer wheel turn more thus eat more, by rotation your tyre regularly you can more or less equalise the 4 tyres wearing.

by suggestion to you replace 2 new tyre and put you current 2 back old tyre forward (balance first)

place you 2 NEW TYRE at rear (balance it too)

Yes, I also suspect its because of the way our MSCP is designed causing the front left tyre to wear not faster.

 

Its a good idea to replace tyres in pair....but just kinda felt its wasted because the front right tyre still in good condition and still have thread...

Link to post
Share on other sites

I did told the mechanic one side tyre more botak than the other side...and he said "try drive for about 5,000 km and see got improvement or not"....

 

But, even with if he had corrected the alignment properly, my botak tyre (I believe) won't last another 5,000 km [:(]

You park in MSCP?

Our MSCP, all make right turn... more pressure, friction and wear on the left front tire.

So, tire rotation is a must in Singapore.

Link to post
Share on other sites

Turbocharged

Pls change tyres in pairs instead of 1.

 

My uncle did that few years back. 1 new tyre with 3 old expiring tyres. on dry road no issue but one day heavy raining he did a brake on a straight but flooding road. The car spin and hit the lamp post. Luckily he suffer only minor whiplash and has recovered but the car was total loss.

 

He say he brake and the whole car spin in the way that the 3 old tyres lose traction.

 

 

Link to post
Share on other sites

Yes, I also suspect its because of the way our MSCP is designed causing the front left tyre to wear not faster.

 

Its a good idea to replace tyres in pair....but just kinda felt its wasted because the front right tyre still in good condition and still have thread...

IS NOT A WAste if you want your driving SAFE and peace of mind.

Is a really waste to throw away our car after 10 years especially our car is still in good condition [rifle]

Link to post
Share on other sites

Turbocharged

IS NOT A WAste if you want your driving SAFE and peace of mind.

Is a really waste to throw away our car after 10 years especially our car is still in good condition [rifle]

 

Wah Lao....thread about tyres also got political undertones.. <_<

↡ Advertisement
Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share

×
×
  • Create New...