Rev_zone Neutral Newbie April 13, 2008 Share April 13, 2008 Where can I find any good spring spacer around? Ride with Eibach seems abit too low and hitting fender so thinking whether should add in spacer or roll the fender will do. ↡ Advertisement Link to post Share on other sites More sharing options...
Furrynadz 5th Gear April 13, 2008 Share April 13, 2008 roll Link to post Share on other sites More sharing options...
Twnll 1st Gear April 13, 2008 Share April 13, 2008 I saw some red rubber thingy at Silent. Suppose to improve ride and prolong life of the shock absorbers Link to post Share on other sites More sharing options...
Subzro Neutral Newbie April 13, 2008 Share April 13, 2008 That's a bump stop... My dad use it on his ride after lowering to counter the "bumpy" effect when on full passenger load... Link to post Share on other sites More sharing options...
Rev_zone Neutral Newbie April 13, 2008 Author Share April 13, 2008 Does it looks something like this --> http://www.autodesigns.com.sg/prod05.htm Link to post Share on other sites More sharing options...
Rev_zone Neutral Newbie April 13, 2008 Author Share April 13, 2008 Wonder whether it's the same as this --> http://www.autodesigns.com.sg/prod05.htm that you saw. Link to post Share on other sites More sharing options...
Subzro Neutral Newbie April 13, 2008 Share April 13, 2008 Nope... Like attached... Link to post Share on other sites More sharing options...
Rev_zone Neutral Newbie April 13, 2008 Author Share April 13, 2008 Can PM me where can I get this kind of spacer? Need that urgently. Thanks Link to post Share on other sites More sharing options...
Frost_s Neutral Newbie April 15, 2008 Share April 15, 2008 bro, this kind of spacers are quite common. i think most shops dealing with suspension should carry it. i was quoted 120rm for a set few months back. But you should be careful abt the installation process. i didn't install as the mechanic told me he's just using cable tie to secure the spacer onto my springs. hahaha. Link to post Share on other sites More sharing options...
Dwoon 1st Gear April 15, 2008 Share April 15, 2008 Go autodesigns..... I've fitted it to the rear and it makes the ride firmer (though bumpier). Also sags less under loads. Link to post Share on other sites More sharing options...
Rev_zone Neutral Newbie April 15, 2008 Author Share April 15, 2008 (edited) Actually there's 2 type of spacer in the market. One use cable tie and the other is different in design which allows the spring to fully sit between the spacer. Most common ones are the cable tie ones which I try to avoid as I didnt feel secure at all. Anyway had already installed the one in red and the blue one is the one which I won't encourage people to use. Edited April 15, 2008 by Rev_zone Link to post Share on other sites More sharing options...
Chucky2007 Turbocharged April 15, 2008 Share April 15, 2008 where did u get the red spacer? can advise how much did u pay? Link to post Share on other sites More sharing options...
Rev_zone Neutral Newbie April 15, 2008 Author Share April 15, 2008 Jeep Chee or RaceTech can find. Link to post Share on other sites More sharing options...
Chucky2007 Turbocharged April 15, 2008 Share April 15, 2008 thanks for info. Link to post Share on other sites More sharing options...
Nutek0 Neutral Newbie April 17, 2008 Share April 17, 2008 I'm driving a Sunny VIP and installed the red ones before, with the intention to boost/strengthen the saggy rear springs (always kenna exhaust pipe hit curb/hump). These red spacers were secured using cable-ties to the actual springs, but the fit wasn't very fitting. In my opinion, there wasn't much difference in the ride quality/handling after the installation. 6 mths later, I fitted in a set of new rear shock absorbers instead, and whilst the new shock absorbers still did not lift up the ride height, the ride quality/handling is much better now. Juz my 2c. Link to post Share on other sites More sharing options...
Hamburger Hypersonic April 17, 2008 Share April 17, 2008 Quote bro, this kind of spacers are quite common. i think most shopsdealing with suspension should carry it. i was quoted 120rm for a set few months back. But you should be careful abt the installation process. i didn't install as the mechanic told me he's just using cable tie to secure the spacer onto my springs. hahaha. yo bro,i notice ur currency is in RM. can share where u did it in Msia Link to post Share on other sites More sharing options...
Rev_zone Neutral Newbie April 18, 2008 Author Share April 18, 2008 One bro in KL fixed it for RM 250 w/installation which is more exp than SG. Did you notice he mentioned also using cable tie to secure? Think this is the one which is not recommended ones. Btw, my spacer was on my ride for a week and will be letting it go soon. $50 cash carry you want? Reason to sell is not this spacer no good but I found blue ones in TW so asking my friend to ship in for me since I on blue blue concept. Link to post Share on other sites More sharing options...
Hamburger Hypersonic April 21, 2008 Share April 21, 2008 while my tein lowered spring does not hit anything, e rear looks abit too low when fully loaded. so does this red thingy helps ↡ Advertisement Link to post Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In NowRelated Discussions
Related Discussions
Wheel bolts and Wheel spacer
Wheel bolts and Wheel spacer
Wheel Spacer Installation DIY
Wheel Spacer Installation DIY
Wheel Spacer, where to buy?
Wheel Spacer, where to buy?
Relaxation this spring
Relaxation this spring
Everest "death zone" set for a spring clean up
Everest "death zone" set for a spring clean up
Japan Spring 2018 Food-Otaku Adventures
Japan Spring 2018 Food-Otaku Adventures
Sembawang Hot Spring to be developed
Sembawang Hot Spring to be developed
Urgent advise needed on Lowering Spring + stock Spring setup
Urgent advise needed on Lowering Spring + stock Spring setup